Ceramic fiber tape is a kind of fiber -shaped light quality, not afraid of fire materials. It has light weight, can withstand high temperature, good thermal stability, low heat conduction rate, smaller heat conduction rate, smaller heating and not afraid of mechanical vibration. Therefore Petroleum, ceramics, glass, electronics and other industries have been commonly used. Ceramic fiber belt is not afraid of fire, and a type of fire material is prevented from being produced from height.
The force between the ceramic fiber tape particles is lost to balance, so that the oxidation of the microcomples of pink pink granules occurs, changes from the dance to solid state, and retains the long diameter ratio of the cylindrical mud. Why does the ceramic fiber tape appear small holes? Let's see the reason:
1. When the ceramic fiber belt contacts the agent, the interface tension of the agent and the mud is very small, and the water polymerization agent in the surrounding hydroponic film of the oxidation of the oxide particles is instantly extracted. The water in the middle loses the driving force to restore the smooth surface, so that the uneven surface formed during the extrusion process can be retained so that the ceramic fiber paper containing is relatively rough;
2. The pressure stress stored in the mud causes a small expansion after leaving the slurry and the spray holes, causing a cracked surface to cause a crack. These cracks are also manifested on the surface of the ceramic fiber insulation blanket;
3. Due to the extraction of water condensate on water, the concentration of the water concentration of the water that has not solidified the mud and the inside of the mud is not solidified. Water flow channel, macro manifestation as the rough surface;
4. Due to the effect of thickness, the water inside the mud is constantly moving towards the agglomerate, driving the oxidation particles surrounded by water in the fiber internal fluid to move towards the already solid surface direction to form a hollow structure.
Ceramic fiber tape is not afraid of fire fiber is non -dense material. Metal melts and slag can infiltrate fiber and cause damage to the furnace. Therefore, it is not afraid that fire fiber is generally not required to be directly contacted with the melting material. It is not afraid that the strength of fire fiber products is lower than that of dense and not afraid of fire materials. Special protection measures should be used in parts that are often mechanically squeezed, collided, and friction.
